Skinny Ties

Here is the before shot. In the tutorial, I took the polka-dot tie and made it as skinny as the stripe tie:

Here is the after shot:

DIRECTIONS:

1) Turn your too-wide thrift store tie upside down. Un-stitch it:

Keep un-stitching till you get to the skinniest part of the tie:

2) Pull the tie form fabric out of the lining (there is probably a real name for this, but I don’t know what it is). This is the piece of the tie that helps keep the tie shape.

3) Trim one side of the tie-form fabric. I free-handed it on the first one, aiming for a finished tie that was about 1 1/2 inches wide. But for the other 4, I traced a skinny tie with a pen right on the tie-form fabric:

4) If you traced it, then cut out the second side. If you’re free-handing it, turn the cut piece upside down to get a matching cut on the second side:

5) Your tie-form material should now look like a skinny tie. Tuck it back into the lining:

6) When you unstitched the tie, one side was overlapping the other, Starting with the side that was being overlapped, trim off some of the silk, tapering the trimmed piece as the tie narrows:

7) With an iron set for silk, press the trimmed silk so that it folds itself along the tie-form fabric:

8) Fold under the cut edge and iron again, so that the ironed piece is narrower than the tie-form fabric:

9) Now it’s time to iron the second side. Note: you may not need to trim the silk on this side:

10) Tuck under the edge of the second side and iron once more. Aim to get the seam in the middle:

If you turn the tie over, it should now look like this (but don’t iron the front, you might damage the silk):

11) Next, using a needle and thread, stitch up the back of the tie. Take your stitches through both the back flaps and catch a bit of the tie-form fabric, but be careful not to reach the front of the tie. It’s pretty easy to hide the hand stitches between the back flaps:

12) If your tie came with a piece for tucking the tail into, you can reattach it now:

And that’s it! In case you’re curious, the first tie took me about 45 minutes. But the next 4 only took about 30 minutes each. I turned these:

Into these:

Other notes:

-Three of the ties I worked with were silk. One was wool. One was polyester. The silk ties were by far the easiest to work with.

-Also, as I progressed, I got better at getting the new back seam centered. The navy and brown stripe tie was my last one and it’s the best as far as the back seam goes:

I hope you enjoyed the tutorial. Happy sewing!